IBM 5721 10Gb Ethernet Short Range PCI-X 2.0 DDR Adapter 573A
For machines: E6C, MHC, MMC, E6D, MMD, E4D, FHA, F2A, EMA, 61D, 510, 590, 285, MMA, 51A, 55A, E8A, 575, E4A, 595, 720, 561, 710, 520, 550, 52A, 505, MMB, MHB, E4S, E4C, E8B, FHB, E4B, E6B,
This item is Refurbished. This item has been tested by Vibrant's team of experienced technicians test to ensure proper operation.
10 Gb Ethernet-SR PCI-X 2.0 DDR Adapter (FC 5721; CCIN 573A) The 10 Gb Ethernet-SR PCI-X 2.0 DDR Adapter is designed to provide a PCI-X based server connection. The adapter conforms to the IEEE 802.3ae 10 Gigabit Ethernet standard and supports jumbo frames. The 10 Gb Ethernet-SR PCI-X supports the following distances: Up to 33 m by using 62.5 um multimode fiber with 200 MHz*km minimum modal bandwidth at 850 nm Up to 300 m by using 50 um multimode fiber with 2000 MHz*km minimum modal bandwidth at 850 nm The adapter is designed to run in standard PCI-X v2.0 and PCI-X v1.0a compliant systems with 64 bit PCI-X BusMaster slots at 133 Mode 1 or Mode 2. The adapter draws power from the PCI-X 3.3 V supplies and is keyed to fit only into a 3.3 V slot. The adapter supports 1M x 8 bit boot FLASH ROM and has a 240 KB on-chip TX packet buffer and a 32 MB on-chip RX packet buffer. The FRU part numbers for the adapter are: Adapter, 03N4590 (Designed to comply with RoHS requirement.) Wrap plug, 11P3847 The adapter provides the following features: Single-slot, short form factor, 6.6 by 4.2 inch, half-length PCI cards 64 bit Direct Bus Mastering on the PCI-X bus Dual Address Cycle for access to 64 bit addresses PCI-X split transactions DMA engine for movement of command, status, and network data across PCI-X 240 KB on-chip TX packet buffer 32 MB on-chip RX packet buffer 1 MB Boot Flash ROM Jumbo frames (9 KB) Interrupts coalescing 802.1q VLAN tagging and stripping (IBM® System i® models do not support VLANs) Conforms to IEEE 802.3ae 10 Gigabit Ethernet standard
Related Models:
IBM 10N8264
IBM 10N9774
IBM 10N9775
IBM 80P6636
IBM 03N4590